PU Rtv Potting Compound Electronic Epoxy Encapsulant Potting Compounds 6800 BK

Excellent Electrical Properties | UL94-V0 Polyurethane Potting Compound                                                                                                       

Product Description

BZ-6800 is a UL94-V0-rated polyurethane potting material (UL No.: QMFZ2.E352175), fully compliant with RoHS and REACH standards. It offers high structural strength, strong substrate adhesion, robust mechanical performance, and superior electrical characteristics. Widely used for potting in electronics and electrical equipment.

Key Product Features

1. Low viscosity, adaptable to manual or automated dispensing;
2. Broad operating temperature range;
3. Stable, high-grade electrical insulation;
4. UL94-V0 flame-retardant grade;
5. Exceptional moisture and waterproof protection, with ultra-low water uptake;
6. Strong bonding to common plastics and metals.

Technical Parameters 

Product Applications

1. Communication Equipment.
2. Power Tools.
3. Controllers.
4. Modules.
5. LED Power Supply.

Directions for Use

1. Pre-potting Preparation: Calibrate scales, prepare potting tools, cleaning tools, check machine settings, check vacuum pump force, etc. 
2. Product Pre-treatment: Place product on a level surface or fixture. Remove dust, clean, degrease, and dry if necessary.
3. Accurate Proportioning: Manual operation requires precise mixing according to the specified ratio and recording. Machine potting requires calibrated ratios and first-article confirmation is recommended.
4. Mixing & Stirring: Manual operation requires thorough stirring or using electric stirrers to ensure homogeneous mixing. Machine potting requires sufficient stirring speed, adjust as needed.
5. Uniform Potting: Manual operation should be done in small, multiple batches to ensure uniformity. Machine potting should follow the programmed path for quantitative dispensing.
6. Inspection or Secondary Potting: After potting, visually inspect as needed. Perform touch-up, bubble removal, or secondary potting if required.
7. Curing: Allow the potted and inspected products to cure at room temperature or with heat assistance (recommended 60°C if needed), according to product and process requirements.
8. Final Product Confirmation: Perform visual inspection and performance testing as required by the customer.

Packing

1. Hardener: Typically 5KG/10KG/25KG/200KG metal or plastic drums.
2. Resin: Typically 25KG/200KG metal or plastic drums.